A sump pump can sit idle for most of the year and then fail on the first night it is needed. Spring storms are when most homeowners find out their pump has quit, often because the float switch stuck or the motor wore out over several seasons.
Common faults and what they point to
- Runs but the water level stays the same: a clogged intake screen, a failed impeller, or a check valve stuck closed
- Turns on and off every few seconds: the check valve is letting water fall back, or the float is set too low
- Never starts: tripped GFCI, a tangled or stuck float, or a burned-out motor
- Runs constantly with a dry pit: the float switch is jammed in the up position
- Loud grinding or rattling: debris in the impeller or worn bearings
Repair or replace?
Many pumps last somewhere around seven to ten years, depending on how often they run. A float switch or check valve on a younger pump is a simple part swap. A pump that is near the end of that range and showing motor trouble is usually better replaced, since the labor to pull it is about the same either way.
A good habit before each spring: pour a bucket of water into the pit and watch the pump start, empty the pit, and shut off. If it hesitates, schedule service while the ground is still frozen and the pump is not under load.
We book sump pump service with local plumbers across Olean, MO.